Resolve spray and wash stain remover? (2023)

Does Resolve stain remover work?

Resolve is a very effective carpet & stain remover! It cleans the toughest spots and stains in both carpet and launderables.

Spray n Wash always works great on getting tough stains out of clothes…. I would highly recommend using it to get those stains out of clothes!!! If you're like me - and manage to get oil and food onto your clothes - then this is the product for you.

Using too much stain remover

Using too much can make the area harder to rinse or dry, especially on carpets and upholstery. Light, repeated applications of a remover work much better than flooding a stain.

Douse the stain with white vinegar, then apply a paste made of equal parts baking soda and vinegar. If this doesn't work, immerse the item overnight in a bucket of water containing a few tablespoons of detergent and vinegar. Rinse and wash the following morning.

And Shout Advanced Stain Lifting Aerosol didn't do much better. In fact, none of the stain treatments did a great job at removing cocoa. Still, most of the stain treatments did do better than just using detergent alone. In the end, it was Resolve Spray and Wash that removed the most stains.

Leaving a product on a garment longer than recommended may damage fabrics.

Always test garment before using by applying to an inconspicuous area. If possible, treat and launder while stain is still fresh. Leaving Spray N Wash max on garments for more than 5 minutes may cause color fading. Do not let dry on garments.

1. Chlorine Bleach and Color-Safe Bleach. Diluted household bleaches are among the most effective stain removers for clothing and linens.

You can use any stain-removing solution you have. Allow it to sit for at least 10 minutes (and up to overnight) and then launder as usual. The stain should be gone, but launder on cool settings and repeat if the stain persists.

How long do you wait to wipe off excess stain?

Wipe the stain off immediately if you'd like a lighter tone. But for a deeper tone, leave the stain on the wood for 5 to 10 minutes before wiping it off. Be sure to wipe off all the excess stain going in the direction of the grain of the wood.

The ideal way to fix a wood stain mistake is to sand the piece down to bare wood, and re-stain. However, this is time-consuming. Applying another layer of stain, painting the piece, or evening the piece with gel stain are other methods that could produce a satisfactory result.

When your washing machine isn't cleaning clothes, the most common reason is that it isn't draining properly, leaving dirt from the first wash in the drum so it's still there after the last rinse. This means you need to clear your washing machine's filter.

The short answer is unfortunately no, not all stains can be removed, and here are three reasons why. The longer a stain is left untreated, the less likely it is to be removed.

Apply isopropyl alcohol to the stain and blot with a clean napkin or cloth, according to Good Housekeeping. You might want to place a paper towel under the fabric to prevent the alcohol from soaking through. You should see the stain start to dissolve almost immediately.

Greasy / Oil Stains – such as hand lotion, hair mousse, lard and butter. Oxidisable Stains – key ingredient in alcoholic drinks, coffee and tea (without milk) and soft drinks. Particulate Stains – such as mud and ground in dirt. Combination Stains – these stains can be a mix of two or more of the above stain types.

Typically, cold water works great on blood, as well as food, beverages and water-based paint, while hot water works best on protein-based stains. Unfortunately, there's no golden rule to stain removal. For example, most food stains should be soaked in cold water, unless it's egg, mustard or a tomato-based product.

How much does it take for Resolve product to be effective? Depending on the stain type, it will take from 30 seconds to 5 minutes. Note: allow the product to sit for no more than 5 minutes.

Reckitt Benckiser makes everything from French's mustard to lubricant. (Do not get those mixed up in your house!) It also makes what is now again being called Spray 'n Wash. Six years ago, Reckitt Benckiser changed the name of the stain pre-treatment liquid to Resolve.

For badly stained items, a quick pre-treat or soak in a Resolve® solution before they go in the wash will help things along– the powders even come with a scoop to help ensure optimum stain removal.

How long does Spray and Wash take to work?

Directions: (1) Turn nozzle to on position. (2) Spray onto the stain, covering it completely (3) Wait 5 minutes maximum. (4) Rub into stain. (5) Wash according to care label instructions in the warmest water recommended.

Leaving a product on longer will not make you “browner”, and in fact can make you over dark, off color, orangy, brassy or create a fast fading or uneven tan. Judge your color after 12-24-48-72 hours.

To create a soap scum remover for the bathroom: Mix equal parts cleaning vinegar, dishwashing liquid, and water in a spray bottle. Shake to mix well and label the bottle.

Product Description

Spray 'n Wash Max Pre-Treat Trigger removes tough stains like grease & motor oil. Just spray and wash.

Laundry Tips and Tricks:

Stain remover spray works best on clothes that are wet or at least damp.

Hydrogen peroxide doesn't actually remove stains—it just makes them invisible! It breaks up strong chemical bonds in stains including ink, and in doing so it makes the stains colorless—but they're still there! As a result you might have found in your tests that peroxide did the best job of “removing” the ink stain.

In a spray bottle, combine 1 cup white vinegar and 1 cup water. Spritz the stain, then blot with a damp cloth. Next, dab with diluted ammonia (1 tablespoon clear ammonia in 1 cup water)—a step probably best saved for once you're home from the office, to avoid drawing attention to the aroma.

Even if that stained shirt has been sitting at the bottom of the laundry bin forever, OxiClean™ Versatile Stain Remover can get out even old, set-in stains. Fill scoop to line 4 per 1 gallon of water. Submerge stained items in solution after dissolved.

Many, probably most, store-bought stains are made with both dye and pigment. If wood stained with these stains is exposed to sunlight or fluorescent light for a while, the dye color will fade away, but the pigment color will remain. The effect is that the stained wood changes color.

The most likely reason is time. When it comes to stain removal, time is the biggest factor. The age of the stain often determines whether it's removable or not. If treated quickly enough, in the hands of a trained professional, almost any stain can be removed from almost any fabric.

Is hot or cold water better for stains on white?

When washing whites, removing dirt and stains is important. Because fading the color of the fabric isn't a concern, it's ideal to wash your clothing in warm water.

If you find a stain on an item that has been through a hot dryer, it doesn't have to be permanent. By using the right laundry products and the right technique, stains that have been dried do come out.

You'll know if you've over-applied your deck stain because there will be sticky patches or puddles that just aren't drying—the wood has absorbed all it can so the remaining stain has nowhere to go.”

You should also consider the type of wood you are staining, amount of stain you're applying, and weather conditions, like humidity, temperature, and air circulation. On average, wood stain takes about 24 to 72 hours to fully dry and cure, though you can typically add a second coat after about four hours.

"The good news is that almost any stain will come out eventually," says Mr. Macpherson. As for stain-removal sprays and pre-treatments, these can be useful, but you will still have to rinse, check the stain and repeat if necessary.

Yes, each layer will darken your project even more. You can also start with a lighter color Gel Stain and layer on darker colors.

Blotchy stain often occurs because wood unevenly absorbs stain, causing some areas to be darker than others. Blotchy stain is more likely to happen on soft woods such as pine. Stain rarely turns out blotchy on hard wood like oak.

If a washing machine is overloaded or detergent is not properly loaded, it won't properly dissolve in water – meaning it ends up on your clothes instead. Laundry detergent stains are annoying, but they don't have to be permanent.

It could be that the washing machine drum has collected greasy residue from previous loads. Try cleaning the drum by running an empty cycle with a cupful of white vinegar or bleach instead of detergent, or look for products specially designed for this purpose.

A common reason why your washing machine is not cleaning clothes properly is because the line leading from the detergent tray to the drum has become clogged with washing powder. This means that just a small amount of detergent actually reaches the drum; the rest gets stuck behind the blockage.

What kind of stains are permanent?

How much does it take for Resolve product to be effective? Depending on the stain type, it will take from 30 seconds to 5 minutes. Note: allow the product to sit for no more than 5 minutes.

Treating coffee stains with Resolve Oxi-Action^® Powder is fast and simple. The best way to remove tough stains like coffee from clothing is to soak the item first using Resolve^®. Then simply wash the item in the washing machine with your normal detergent, adding an extra dose of Resolve^® to get superior results.

Resolve® Spot & Stain Remover breaks down messes caused by red wine, food grease, mud, coffee and more. Its pleasant scent neutralizes odors to leave your carpet smelling fresh.

Resolve Bright & White™ is a Bleach Alternative which removes stains and is safe for both coloured and white clothes. For every wash load, add Resolve liquid and detergent before adding clothes. It can be used as pre-treat and pre-soak to remove stains also.

Use a fresh clean cloth to gently blot or dab the damp parts of the carpet. This will also help remove some of the stickiness. Once all or most of the water is absorbed, pour some white vinegar onto a fresh cloth or towel. Again, gently dab it onto the affected areas.

Why Is the Carpet Sticky? The most likely cause of your sticky carpet after cleaning is leftover residue. When your carpet is cleaned, either by a professional or an at-home shampooer, it works by mixing chemicals from a carpet cleaner with water, and then spraying the mixture under high pressure into your carpet.

You shouldn't need to make more than two passes with cleaning solution (especially if you pre-treated stains) when deep cleaning your carpet. Make additional passes without spray button pressed.

Resolve Urine Destroyer permanently eliminates urine stains, neutralizes odors on contact and helps prevent pet remarking. Formula utilizes high efficacy 100% bio-based polymer technology to remove the odor- causing molecules. Great for both pet and people accidents.

Mix a small amount of laundry detergent with some cool water, and gently rub it into the stain. (If you don't have any laundry detergent on hand, a gentle dish soap, like Dawn, is actually a great substitute.) Let it sit for up to a few minutes before rinsing it with water.

How long does Resolve take to dry?

Leave for 2 hours, or until dry, then vacuum. Before cleaning: Vacuum carpet thoroughly to remove loose dirt. Test a small, hidden area for colorfastness and examine when dry.

Wet cleaning or carpet stains can cause excess moisture to reach the carpet backing. As the water evaporates and the carpet dries the stains can travel back to the surface of the carpet via the carpet fibres. Causing the stain to reappear on the surface of the carpet.

Hydrogen peroxide is one of your best options for old, ground-in stains of nearly every variety, and luckily, it's easy to use. Mix a teaspoon of 3 percent hydrogen peroxide with a little cream of tartar or a dab of non-gel toothpaste. blot the paste on the stain with a soft cloth until the stain is gone.

You can try a mixture of white vinegar, Dawn dish soap, and water in a spray bottle. Use 1/4 cup of white vinegar, 1 tbsp. of Dawn dish soap, and fill with water. Spray area liberally and let soak for 5-10 minutes and then proceed with blotting with a clean, dry towel until stain is removed.